Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont'd)

PISTON-TO-BORE CLEARANCE

1. Using a bore gauge, measure cylinder bore for wear, out-of-round and taper. Standard inner diameter: Moving the bore gauge as shown, take the

83.000 - 83.050 mm (3.2677 - 3.2697 in) minimum diameter. Wear limit:

0.20 mm (0.0079 in) Out-of-round (X — Y) limit:

0.015 mm (0.0006 in) Taper (A — B) limit:

6.010 mm (0.0004 in) If it exceeds the limit, rebore all cylinders. Replace cylinder block if necessary.

2. Check for scratches and seizure. If seizure is found, hone it. @ If both cylinder block and pistons are replaced with new ones, select pistons having the same piston grade num- bers as those punched on the cylinder block upper surfaces.

3. Measure piston skirt diameter. Piston diameter “A”: Refer to §.D.S. Measuring point “a’’ (Distance from the bottom): 14 mm (0.55 in)

4.

Check that piston-to-bore clearance is within specification.

Piston-to-bore clearance “B”:

0.015 - 0.035 mm (0.0006 - 0.0014 in) SS

5. Determine piston oversize according to amount of cylinder wear. Oversize pistons are available for service. Refer to S.D.S.

6.

Cylinder bore size is determined by adding piston-to-bore

clearance to piston diameter “A”. Rebored size calculation: : D=~A+B-C where, D: Bored diameter A: Piston diameter as measured B: Piston-to-bore clearance C: Honing allowance 0.02 mm (0.0008 in)

7. Install main bearing caps, and tighten to the specified torque to prevent distortion of cylinder bores in final assembly. ~ Cut cylinder bores. @ When any cylinder needs boring, all other cylinders must also be bored. @

Do not cut too much out of cylinder bore at a time. Cut

only 0.05 mm (0.0020 in) or so in diameter at a time. . Hone cylinders to obtain specified piston-to-bore clearance.

10. Measure finished cylinder bore for out-of-round and taper.

Measurement should be done after cylinder bore cools

down. EM-36

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.