Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER HEAD - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER HEAD - Nissan 180SX S13 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Assembly (Cont'd)

7. Install carnshaft sprockets. Sprocket bolt: (9): 14 - 19 N-m (1.4 - 1.9 kg-m, 10 - 14 ft-lb) When tightening bolts, fix camshaft to prevent it from rotating.

SEM5256

8. Adjust timing belt tension. Refer to TIMING BELT.

9. Reinstall remaining parts.

Installation

1. Set No. 1 piston at T.D.C. on its compression stroke as follows: (1) Align crankshaft sprocket aligning mark with mark on oil pump body.

(2) Align camshaft sprocket aligning mark with mark on timing belt rear cover.

Knock pin SEM833B

2. Install cylinder head with new gasket. @

Be sure to install washers between bolts and cylinder

Cylinder head bolt head. washer direction @ Do not rotate crankshaft and camshaft separately, or valves will hit piston heads. Sd Cylinder head side

SEM5558

EM-26

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.