Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER HEAD - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER HEAD - Nissan 180SX S13 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Inspection (Cont'd)

3. Heat cylinder head to 150 to 160°C (302 to 320°F)

4. Press fit valve seat until it seats on the bottom

5. Cut or grind valve seat using suitable tool at the specified dimensions as shown in S.D.S.

6. After cutting, lap valve seat with abrasive compound.

7. Check valve seat contact condition.

VALVE DIMENSIONS

T (Margin thickness) Check dimensions in each valve. For dimensions, refer to $.D.S. When valve head has been worn down to 0.5 mm (0.020 in) in margin thickness, replace valve. Grinding allowance for valve stem tip is 0.2 mm (0.008 in) or less.

VALVE SPRING

$ (Ourof-squar Squareness

1. Measure “’S" dimension. Out-of-square: Less than 1.8 mm (0.071 in)

2. If it exceeds the limit, replace spring,

‘SEw2aaA, Pressure Check valve spring pressure,

CompretonlenathLond (kg,
0 (0)0 (0,0)
8 (0.31)Approx. 235 (24, 53)
16.5 (0.650)Approx, 539 (55, 121)

EM-23

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.