Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Assembly (Cont’d)

3. Measure crankshaft end play. Crankshaft end play: Standard

0.05 - 0.18 mm (0.0020 - 0.0071 in) Limit

0.3 mm (0.012 in) lf beyond the limit, replace bearing with a new one.

4. Install connecting rod bearings in connecting rods and connecting rod caps. @ Confirm that correct bearings are used. Refer to “Inspection”. ® Install bearings so that oil hole in connecting rod aligns with oil hole of bearing.

) A, SEM159B Install pistons with connecting rods. EM03470000 or suitable toatl install them into corresponding cylinders with Tool. Be careful not to scratch cylinder wall by connecting rod. @eero Arrange so that front mark on piston head faces toward front of engine.

SEM769B

b. Install connecting rod bearing caps. Tighten connecting rod bearing cap nuts to the specified torque. Connecting rod bearing nut: (1) Tighten to 14 to 16 N-m (1.4 to 1.6 kg-m, 10 to 12 ft-Ib). (2) Tighten to 41 to 44 N-m (4.2 to 4.5 kg-m, 30 to 33 ft-ib) or if you have an angle wrench, tighten bolts 60 to 65 degrees clockwise.

6. Measure connecting rod side clearance. Connecting rod side clearance: Standard

0.20 - 6.35 mm (0.0079 - 0.0138 in) Limit

0.4 mm (0.016 in) if beyond the limit, replace connecting rod and/or crankshaft.

/ ky / if SEM162B EM-42

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.