Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER BLOCK - Nissan 180SX S13 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection (Cont'd)

PISTON RING END GAP

Piston Press-fit End gap: — y

Top ring

0.25 - 0.42 mm (0.0098 - 0.0165 in) | LO) |

2nd ring

7

0.38 - 0.64 mm (0.0150 - 0.0252 in) ning»

Oil ring

0.20 - 0.76 mm (0.0079 - 0.0299 in) Max. limit of ring gap:

1.0 mm (0.039 in) SEM5S9A lf out of specification, replace piston ring. If gap still exceeds the limit even with a new ring, rebore cylinder and use oversized piston and piston rings. Refer to $.D.S.

CONNECTING ROD BEND AND TORSION

Bend and torsion: eB Limit 0.1 mm (0.004 in) per 100 mm (3.94 in) length lf it exceeds the limit, replace connecting rod assembly.

SEMi506 Steaichted

CYLINDER BLOCK DISTORTION AND WEAR

mayannense

1. Clean upper face of cylinder block and measure the distor-

—) ei Be : tion. Limit:

0.10 mm (0.0039 in)

2. If out of specification, resurface it. The resurfacing limit is determined by cylinder head resur- = ad facing in engine. Feeler gauge Os {0} Amount of cylinder head resurfacing is “A”. \ Amount of cylinder block resurfacing is “B”. SEM123C The maximum limit is as follows: A+ B = 0.2 mm (0,008 in) Nominal cylinder block height from crankshaft center: 204.75 - 204.85 mm (8.0610 - 8.0649 in)

3. if necessary, replace cylinder block.

EM-35

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.