OIL PAN - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › OIL PAN - Nissan 180SX S13 Workshop Manual
OIL PAN
OIL PAN
Removal
1. Drain engine oil.
2. Remove front stabilizer bar.
3. Loosen front engine mounting nuts. (Do not loosen com- pletely.) > Lift up engine slightly using engine slingers.
(\ A
5. Remove oil pan. = VES ; eye ENS
(1) Insert Tool between cylinder block and oil pan.
oy yy @
Do not insert Tool into oil pump or rear oil seal retainer
portion, or aluminum mating face will be damaged. @ Do not insert screwdriver, or oil pan flange will be deformed.
(2) Slide Tool by tapping its side with a hammer, and remove oil pan.
SEM&84A [ ~ Installation
1. Before installing of pan, remove all traces of liquid gasket from mating surface using a scraper. @ Also remove traces of liquid gasket from mating surface of cylinder block.
oS
2. Apply liquid gasket to oil pump gasket and rear oil seal a Geen retainer gasket.
(0.59) 5 020 FF
SEM356C Unit: mm (in)
EM-7
Parts & tools for this job For Nissan 180SX
- PARTOil filterSearch: Nissan 180SX oil filter
- TOOLOil filter wrenchSearch: oil filter wrench
- FLUIDEngine oilSearch: Nissan 180SX engine oil
As an Amazon Associate we earn from qualifying purchases.