CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
CYLINDER HEAD
IS!
CYLINDER HEAD
Disassembly (Cont'd)
7. Remove valve oif seals with Tool or suitable tool Kv 10107901
Inspection
CYLINDER HEAD DISTORTION
Head surface flatness: Less than 0.1 mm (0.004 in) If beyond the specified limit, replace it or resurface it. Resurfacing limit: The resurfacing limit of cylinder head is determined by the cylinder block resurfacing in an engine. Amount of cylinder head resurfacing is “A’ Amount of cylinder block resurfacing is Distorsion of surface: The maximum limit is as follows: Less than 0.1 mm (0.004 in) A + B= 0.2 mm (0.008 in) After resurfacing cylinder head, check that camshaft rotates freely by hand. If resistance is felt, cylinder head must be replaced. Nominal cylinder head height: 125.9 - 126.1 mm (4.957 - 4.965 in)
semso5a,
CAMSHAFT VISUAL CHECK
Check camshaft for scratches, seizure and wear.
CAMSHAFT RUNOUT
1. Measure camshaft runout at the center journal Runout (Total indicator reading): Limit 0.05 mm (0.0020 in)
2. If it exceeds the limit, replace camshaft.
*: Total indicator 098009 oe sro
EM-19
Parts & tools for this job For Nissan 180SX
- PARTEngine gasket setSearch: Nissan 180SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.