Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER HEAD - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER HEAD - Nissan 180SX S13 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Inspection (Cont'd)

4.

Heat cylinder head to 150 to 160°C (302 to 320°F) and

press service valve guide onto cylinder head. Projection " ¢ "

15.1. 15.3 mm (0.594 - 0.602 in)

Unit:_men find SeMosee

5. Ream valve guide. Finished size: Intake and Exhaust

6.000 - 6.018 mm (0.2362 - 0.2369 in)

VALVE SEATS

Check valve seats for any evidence of pitting at valve contact

surface, and reseat or replace if it has worn out excessively, © Before repairing valve seats, check valve and valve guide

for wear. If they have worn, replace them. Then correct

valve seat. © Cut with both hands to uniform the cutting surface.

REPLACING VALVE SEAT FOR SERVICE PARTS

1. Bore out old seat until it collapses. The machine depth stop should be set so that boring cannot continue beyond the bottom face of the seat recess in cylinder head

2. Ream cylinder head recess. Reaming bore for service valve seat Oversize [0.5 mm (0.020 in)]: Intake

36.500 - 36.516 mm (1.4370 - 1.4376 in) * Exhaust Units men fin} semser8

30.500 - 30.516 mm (1.2008 - 1.2014 in)

Reaming should be done to the concentric circles to valve

guide center so that valve seat will have the correct fit.

EM-22

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.