Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER HEAD - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER HEAD - Nissan 180SX S13 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

CAUTION: @ When installing sliding parts such as camshaft, camshaft bracket and oil seal, be sure to apply new engine oil on their sliding surfaces. © When tightening cylinder head bolts and camshaft bracket bolts, apply new engine oil to thread portions and seat surfaces of bolts.

© Do not put hydraulic vaive lifters upside down, otherwise air will enter valve lifter, causing it to make a noise. © Do not disassemble hydraulic valve lifter. Attach tags to valve lifters so as not to mix them up. © Valve lifters are required to put in engine oil.

seMs208 Removal 1, Remove timing belt Refer to “Removal” of TIMING BELT.

2. Drain coolant from radiator.

3. Disconnect exhaust manifold from cylinder head.

4. Remove cylinder head with intake manifold @ Head warpage or cracking could result from removing in incorrect order. © Cylinder head bolts should be loosened in two or three steps.

semszae

EM-17

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.