Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

CYLINDER HEAD - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 180SX S13 Workshop Manual
EM engine mechanicalCYLINDER HEAD - Nissan 180SX S13 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Installation (Cont'd)

3. ‘Tighten cylinder head bolts in numerical order. © Tightening procedure (1) Tighten bolts to 29 N-m (3.0 kg-m, 22 ft-lb). (2) Tighten all bolts to 103 N-m (10.5 kg-m, 76 ft-lb). (3) Loosen all bolts completely. (4) Tighten all bolts to 29 Nm (3.0 kg-m, 22 ft-1b). (8) Tighten all bolts to 103 Nem (10.5 kg-m, 76 ft-lb) or if an angle wrench is available, tighten bolts 85 to 90 degrees clockwise

4. Install timing belt and adjust belt tension. SEMsS6 Refer to “Installation” of TIMING BELT.

EM-27

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.