Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual13 · EM engine mechanical
13 · Engine

Inspection (Cont'd) - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › Inspection (Cont'd) - Nissan 180SX S13 Workshop Manual
EM engine mechanicalInspection (Cont'd) - Nissan 180SX S13 Workshop Manual

Inspection (Cont'd)

TURBOCHARGER

Inspection (Cont'd)

Condition 3: Excessively high oil consumption or exhaust shows pale blue smoke

Probable cause Corrective action Oil leak at the connection of lubricating oil passage ¥ Correct the connection.

Oil leak at oi! seal of turbine

Oil leak at oi! seal of compressor po Replace turbocharger assembly.

Worn journal or bearing ¥

1. Inspect turbine and compressor wheel as follows: @ Visually check for cracks, clogging, deformity or other damage. @

Revolve wheels to make sure that they turn freely without

any abnormal noise or friction. @ Measure play in axial direction. Play (axial direction):

0.013 - 0.097 mm (0.0005 - 0.0038 in)

SEF7268

2.

Check operation of by-pass valve controller.

/, Mercury manometer @

Move by-pass valve to make sure that it is not sticking or

r By-Pass valve controller scratched. ! .

@ Measure rod end play of the by-pass valve controller.

f Do not apply excessively high pressure to controller diaphragm. i

By-pass valve controller stroke/pressure:

0.38 mm (0.0150 in)/78.6 - 84.0 kPa (786 - 840 mbar, e 590 - 630 mmHg, 23.23 - 24.80 inHg) compressed

Dial indicator /

Always replace the turbocharger as an assembly if necessary.

SEC727B

EM-30

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.