ADJUSTMENT (Mode! R180) - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ADJUSTMENT (Mode! R180) - Nissan 200SX S12 Workshop Manual
ADJUSTMENT (Mode! R180)
ADJUSTMENT (Mode! R180)
Tooth Contact ‘teoth contact pattern check is necessary to | 3. Hold companion flange steady by hand and correct relationship between ring gear and rotate the ring gear in both directions. pinion, id gear set which are not positioned properly be noisy, o have short fife or both, With a n check, the most desirable contact for tow sa level and long fife can be assured, Thoroughly clean ring gear and drive pinion ‘weth. Sparingly apply a mixture of powdered ferric oxide and oii or equivalent to 3 or 4 teeth of ring gear drive side. P0908
Usually the pattern will be correct if you have caloulated the shims correctly and the becklash is correct. However, in extremoly rare cases you will have to Ind-error processes until you get a good tooth contact pattern.
The tooth pattern is the best indication of how
woll a differentia! has been set up. Hoel contact Face contest ‘Tos contact Flank contact
To correct, increase thickness of pinion rachca thickness af pinion height adiuating washer in order to bring hhaight adjusting veanher In oeger deve pinion close toring gear. drva pinion go away fram ring
sPD007
Parts & tools for this job For Nissan 200SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 200SX
As an Amazon Associate we earn from qualifying purchases.