ASSEMBLY (Model R200) - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ASSEMBLY (Model R200) - Nissan 200SX S12 Workshop Manual
ASSEMBLY (Model R200)
ASSEMBLY (Model R200)
Differential Carrier (Cont'd)
12, Align mark on bearing cap with that on
14. Measure ring gear-to-drive pinion backlah carrier and install bearing cap on gear cari with a dial indicator.
P0828 sro Ring gear-to-drive pinion backlash:
13. Apply multi-purpose grease to cavity at sealing
0.13 - 0.18 mm lips of oil seal, (0.0051 - 0.0071 in)
¢ If backlash is too small, decrease thickness ,
Install side oil seal.
right shim and increase thickness of left shim |
by the same amount, If backlash is too great, reverse the above pro. cedure, Never change the total amount of shims as it will change the bearing preload. 16, Check total preload with Tooi. When checking preload, turn drive pinion in both directions several times to set be: P0660 Toot number: KV38100200( - }
' Tool number: ST3127S000 (See J25765-A) | Total preload: i
1.23- 2.30 Nem | {125 - 23.5 kg-cm, 10.9 - 20.4 in-tb)
PD-30 i
Parts & tools for this job For Nissan 200SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 200SX
As an Amazon Associate we earn from qualifying purchases.