Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual12 · PD - Propeller Shaft & Differential
12 · General

ASSEMBLY (Mode! R180) - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › ASSEMBLY (Mode! R180) - Nissan 200SX S12 Workshop Manual
PD - Propeller Shaft & DifferentialASSEMBLY (Mode! R180) - Nissan 200SX S12 Workshop Manual

ASSEMBLY (Mode! R180)

ASSEMBLY (Mode! R180)

Differential Carrier {Cont'd}.

19, Measure ring gear-to-drive pinion backtash with © If preload is too great, add the same amount of a dial indicator. shim to each side. * if preload is too small, remove the same amaunt of shim ta each side. Never add or remove a different number of shim for each side as it will change ring gear-todrive pinion backlash.

Ring gear-to-drive pinion backlash:

0.13- 0.18 mm (0.0061 - 0.0071 in) © If backlash is too small, decrease thickness of right shim and increase thickness of left shim.

4. Recheck ring gear-to-drive pinion bec by the same amount. because increase or decrease in thick Hf backiash is too great, reverse the above pro: shims will cause change of ring gear-to-pinion cedure, backlash. Nover change the total amount of shims as it will

16. Check runout of ring gear with a dial indicator, change the bearing preload, 14, Check total preload with Tool. When checking preload, turn drive pinion in both directions sevaral times to set bearing rollers.

shes Runout timit: po3ao

0.05 mm (0.0020 in} Tool number: 8731275000 {See J25765-A} Total preload:

1.0-23Nm (10 - 23 kg-cm, 8,7 - 20.0 in-Ib}

PD-56

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.