Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual12 · PD - Propeller Shaft & Differential
12 · General

ADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › ADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual
PD - Propeller Shaft & DifferentialADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual

ADJUSTMENT (Model R200)

ADJUSTMENT (Model R200)

Drive Pinion Height (Cont'd). Drive Pinion Preload |. Calculate washer thickness following the chart 1, To determine pinion bearing preload, disas- alow. semble pinion height/bearing preload tools ‘and measure thickness of lead washer. This is the correct size pinion bearing adjusting washer required, 'f @ lead washer is not available, use a piece of thick roll solder to obtain preload washer size.

Line # OPERATION
1, | Saedera number00mm
2, | Dal indicator coving (Step 8)
| ADD lin ‘ond 2
“factor {from drive pinion) (Step 7!
HP factor sign
PLUS SIGN G line 5; SUBTRACT line &
from 3. Enter difference on line 6
WINUS SIGN EJ line 6; AOD and 4, Enter sum on line 6 3
and 4, Enter sum on line 6
Washer site

Example: Dial Indicator Reading:

0.3 mm. roses Number on Pinion Hi +2

2. Select the proper washer (Refer to S.D.S.).

3.00 (standard measure) ® If you cannot find shims with the desired +0.3_ {indicator reading) thickness, use shims s0 that the total thickness

3.3. {Pinion head is plus, so you is the closast to the calculated value.

0.02 SUBTRACT it) © Sometimes the corract dimension cannot be set

3.28 (mm = total pinion washer you with wathers alone. In these cases, wathars may be used will need) in combination with drive pini bearing adjusting spacers. {Refer to $.0.S.) Select the proper washer (Refer to S.D.S.}. you cannot find the desired thickness of washer, wether so that thickness is the closest to the ated valua. Example:

3.28 mm (Calculated total pinion washer in step 8) + The correct washer is 3.27 mm (Part number 38154-P6023}

PD-19

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.