Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual12 · PD - Propeller Shaft & Differential
12 · General

ADJUSTMENT (Model R180) - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › ADJUSTMENT (Model R180) - Nissan 200SX S12 Workshop Manual
PD - Propeller Shaft & DifferentialADJUSTMENT (Model R180) - Nissan 200SX S12 Workshop Manual

ADJUSTMENT (Model R180)

ADJUSTMENT (Model R180)

Drive Pinion Height (Cont'd)

Drive Pinion Preload

Calculate washer thickness following the chart

1.

To determine pinion bearing pretoad, disas-

below. semble pinion height/bearing preload tools

and measure thickness of lead washer. This is

the correct size pinion bearing adjusting washer

Ee ‘OPERATION

required. Standard numbee

Hf @ lead washer is not available, use a piece of

ial Inaicarar reeding (Step 6)

thick roll solder to obtain preload washer size.

‘ADO linas 1 and 2 “factor (trom dive pinion) (Step 7) "H" factor aga ©

PLUS SIGN

[line §; SUBTRACT line 4 from 2. Entar aitference on tine 6 MINUS SIGN [=] line 5: ADD lines 2 and &. Enter turn on line 6 Wosher size - | Example: Dial Indicator Reading:

0.3 mm. srpses Number on Pinion Head: +2

2. Select the proper washer (Refer to S.D.S.).

3.00 (standard measure) *

If you cannot find shims with the desired

+0.3 {indicator reading)

thickness, use shims so that the total thickness

3.3 (Pinion head is plus, so you is the closest to the calculated value.

0.02 SUBTRACT it) * Sometimes the correct dimension cannot be set

3.28 {mm = total pinion washer you with washers alone. In these cases, washers may will need) be used in combination with drive pinion

bearing adjusting spacers. (Refer to S.D.S.)

Select the proper washer (Refer to $.D.S.). you cannot find the desired thickness of washer,

washer so that thickness is the closest to the

(culated value. Example:

3.28 mm {Calculsted total pinion washer in step 8) The correct washer is 3.27 mm (Pert number 38154-P6023).

PD-45

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.