Workshop Manuals Factory service & repair Nissan and Datsun
01 Nissan-S110 S12 S13 S14 S15 Silvia 200SX 240SX02 INDEX03 GI - General Information04 MA - Maintenance05 EM - Engine Mechanical06 LC - Engine Lubrication & Cooling07 EF&EC - Fuel & Emission Control08 FE - Engine Control, Fuel & Exaust09 CL - Clutch10 MT - Manual Transmission11 AT - Automatic Transmission12 PD - Propeller Shaft & Differential13 FA - Front Axle & Suspension14 RA - Rear Axle & Suspension15 BR - Brake System16 ST - Steering System17 BF - Body18 HA - Heater & Air Conditioner19 EL - Electrical System20 Inch/Metric Converion Tables21 Quick Reference Chart
Nissan and Datsun Nissan 200SX S12 1986 Workshop Manual12 · PD - Propeller Shaft & Differential
12 · General

ADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual

Make
Nissan and Datsun
Model
200SX Nissan 200SX S12 1986 Workshop Manual
Section
General › ADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual
PD - Propeller Shaft & DifferentialADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual

ADJUSTMENT (Model R200)

ADJUSTMENT (Model R200)

Side Bearing Preload {Cont‘d).

13, Caloulate washer thickness following the charts

10. Turn weight block a few times to ensure that

bearing is properly seated.

below.

11. Read dial indicator.

Normal indication:

Left (ring gear} side:

0.10 - 0.30 mm (0.0039 - 0.0118 in)

LINE # OPERATION ©

If the needle fluctuates erratically, then bearing

tL | Left side etmnderd number 206mm is either dirty or defective and should be

cleaned or replaced.

Enter “A” factor [gear earierh 2L__| BL | Emer "D" factor (citferontial caved aL | Enter “E* fector (ott Deering) BL | AOD Liner 1L, 2L, 34. and 4L. Enter SUM OL | Enter "" factor (differential cose) 7 | SUBTRACT Line 61 from BL — Enter DIFFERENCE BL | Enter “Hr tactor (ing goer! L | Enter “A” factor’ eign © PLUSSIGN + Line GL; SUBTRACT Line BL feom 7L. sr08e9 Enter ditforanes on Line 10L.

MINUS SIGN

— Line 9L: AOD Linas 71, 12, Measure both beerings in the same way and and BL. Enter sam on Line 104.

write the left side bearing measurement next

tou Late ale ane a to "E” and the right side bearing measurement

next to “F”,

PD-22

Parts & tools for this job For Nissan 200SX

As an Amazon Associate we earn from qualifying purchases.