ADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ADJUSTMENT (Model R200) - Nissan 200SX S12 Workshop Manual
ADJUSTMENT (Model R200)
ADJUSTMENT (Model R200)
To avoid any confusion while. calculating bearing
2. Slide pinion rear bearing inner race, bearing shims, it is absolutely necessary to stay with the preload adapter and pinion bearing adjusting metric system. If you measure anything in inches, spacer over hex head long bolt. the results MUST be converted to the metric system. You can use a, conversion chart or a Tool calculator as illustrated, Pinion rear bearing (-——beh Pinion baneing adjusting . pacar } 1
Tool numb seosa1 Bearing preload adapter (J25269-26)
3. Install these parts into gear carrier,
4. Stand front bearing pilot support on the bench with the appropriate side up and as
Setting Up Each Tools —___
semble front pinion bearing pilot, front pinion bearing inner race and lead preload washer. up each tool, rear pinion bearing and front Ensure that all parts are seated, pinion bearing before adjusting pinion height and drive pinion bearing preload, a a
1. Instatl rear pinion bearing pilot into gauge plate and slide over hex head long bolt,
ZLNs— Pinion front bewting nner tin
rm
srossy Tool number: P0532 ® Lead preload washer Tool number: 1425269.25) ® Hex head long bolt {25269-23) ® Front pinion bearing pilot ® Gauge plate (325269-1) (426269:3) © Rear pinion besring pilot (J25269-2) © Front bearing pilot support (25269.29)
PD-16
Parts & tools for this job For Nissan 200SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 200SX
As an Amazon Associate we earn from qualifying purchases.