ASSEMBLY (Model R200) - Nissan 200SX S12 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 200SX Nissan 200SX S12 1986 Workshop Manual
- Section
- General › ASSEMBLY (Model R200) - Nissan 200SX S12 Workshop Manual
ASSEMBLY (Model R200)
ASSEMBLY (Model R200)
Differential Carrier (Cont'd).
+ If pretoad is too great, add the same amount of © If the backlash varies greatly when the runout shim to each side. of the ring gear is within a specified range, the * If preload is too small, remove the same hypoid gear set or differential case should be amount of shim to each side, | Never add or remove a different number of shims
18. Check tooth contact. for sach side as it will change ting gear-to-drive Refer to Adjustment, | pinion backlash.
19. Install rear cover and gasket.
sPosst 18, Recheck ring gear-to-drive pinion backlash because increase or decrease in thickness of shims will cause change of ring gear-to-pinion backlash. 17, Check runout of ring gear with e dial indicator. t Hy I t i t
ornsee
0.06 mm {0.0020 in} «If backlash varies excessively in different places, the variance may have resulted from foreign matter caught between the ring gear and the differential case.
PD-31
Parts & tools for this job For Nissan 200SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 200SX
As an Amazon Associate we earn from qualifying purchases.