Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - D Series07 Engine - L Series08 Engine - T Series09 Emission control10 Engine management system - MEMS11 Engine management system - PGMFi12 Engine management system - EDC13 Fuel delivery system14 Cooling system15 Cooling system - L Series16 Manifold & exhaust systems17 Clutch18 Manual gearbox - R6519 Manual gearbox - PG120 Automatic gearbox21 Drive shafts22 Steering23 Suspension24 Brakes25 Restraint systems26 Body27 Heating & ventilation28 Air conditioning29 Wipers & washers30 Electrical31 Instruments
Rover 400 Workshop Manual (1995-2000)12 · Engine management system - EDC
12 · Engine

Air cleaner element (page 2 of 2)

Make
Rover
Model
400 Workshop Manual
Year
1995–2000
Section
Repairs
Engine management system - EDCAir cleaner element · page 2 of 2
Diagram
  1. Release cable from clips on bonnet platform closing panel.
Release cable from clips on bonnet platform closing panel.
  1. Remove cable adjusting nut from abutment bracket.
  2. Release inner cable from lever on fuel injection pump.
Release inner cable from lever on fuel injection pump.
  1. Release cable from bulkhead.
Release cable from bulkhead.
  1. Remove trim screw and scrivet securing closing panel in drivers footwell. Remove panel.
Remove trim screw and scrivet securing closing panel in drivers footwell. Remove panel.
  1. Depress nylon clip, disconnect throttle cable from pedal and remove cable.

Parts & tools for this job For 1995 Rover 400

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.