Remote linkage assembly - KV6

Refit

1. Clean master cylinder and servo mating surfaces.
2. Lubricate reservoir spigots with brake fluid and locate reservoir fully into seals.
3. Fit NEW ’O’ ring to adapter housing.
4. Align servo push rod and fit master cylinder to servo, tighten nuts to 25 Nm.
5. Connect primary and secondary brake pipes, tighten unions to 19 Nm.
6. Connect clutch hose to adapter.
7. Connect multiplug to reservoir cap.
8. Bleed brake system. See Adjustments.

REMOTE LINKAGE ASSEMBLY - KV6

Service repair no - 70.35.50

1. Remove brake servo. See this section.