Workshop Manuals Factory service & repair Rover
Rover 800 Workshop Manual (1996-1999)18 · Drive shafts
18 · Transmission

Drive shaft dynamic damper - KV6

Make
Rover
Model
800 Workshop Manual
Year
1996–1999
Section
Repairs › Drive shaft dynamic damper - KV6
Drive shaftsDrive shaft dynamic damper - KV6

DRIVE SHAFT DYNAMIC DAMPER - KV6

Service repair no - 47.10.33

  1. Remove drive shaft outer joint. See this section.
  2. Clean drive shaft with emery cloth to remove rust and lubricate shaft to aid removal of damper.
Drive shaft dynamic damper - kv6 – Clean drive shaft with emery cloth to remove rust and lubricate shaft to aid removal of da
  1. Remove clip and remove damper.

Refit

  1. Lubricate shaft and fit new damper. Fit new damper securing clip.

NOTE: Dampers for LH and RH shafts are not interchangeable.

  1. Fit drive shaft outer joint. See this section.
  2. Measure and mark drive shaft for damper position.
Drive shaft dynamic damper - kv6 – Measure and mark drive shaft for damper position.

Damper position, Manual and Automatic models: RH shaft X = 402 - 408 mm LH shaft X = 270 - 276 mm

  1. Secure damper clip.
  2. Fit drive shaft. See this section.

Parts & tools for this job For 1996 Rover 800

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.