Volumetric sensors

The remote control consists of an electronic circuit and a radio frequency emitter that is battery supplied.

Whenever the control button is pressed the remote control sends the radio code with a range of about 10 metres.

The luminous LED on the key flashes to indicate the correct button operation.

It also indicates a low battery condition by means of a single brief flash each time the button is pressed.

If the button remains pressed for more than 20 seconds the control signal is suspended to avoid useless battery discharging. Releasing and pressing again will activate the signal once more.

Every remote control has its own code.

VOLUMETRIC SENSORS

The volumetric sensors allow an additional surveillance, controlling that there are no intrusions into the vehicle. They are built into the ceiling light and one acts as sender and the other as receiver.

INDICATOR/DISSUADOR LED

This red LED is situated in the upper trim of the steering column, and indicates the system condition and any faults.

EMERGENCY KEY SWITCH

The key switch of the emergency circuit, located on the control unit/siren can cut out, when necessary, the alarm system.

DEACTIVATION

This is obtained by turning the emergency key anti-clockwise (OFF position).

ACTIVATION

This is obtained by turning the emergency key clockwise (ON position).

NOTE The emergency key switch is only accessible after raising the protection hood on the control unit lock.
Always keep the key switch hood well closed to avoid water or other substances seeping in that could damage or put out of use the alarm control unit.

SWITCHES

To check the door opening the switches are used that control the front ceiling light, whereas for the engine compartment and luggage compartment lids there are two special switches.