Wheel hub (page 2 of 2)

Refit

10. Position the wheel hub and drive shaft on a press, place supports beneath the wheel studs and press the drive shaft from the wheel hub.
10. With an assistant depressing the brake pedal,
11. Connect ABS sensor multiplug and secure
12. Fit road wheel and tighten nuts to 140 Nm (103
13. Remove stand(s) and lower vehicle.
1. Clean drive shaft splines, wheel hub and axle mating faces, ABS sensor and sensor recess.
2. Fit drive shaft to axle casing.
3. Lubricate new bearing hub 'O' ring with clean differential oil. CAPACITIES, FLUIDS AND LUBRICANTS, Lubrication.
4. Fit 'O' ring to wheel hub.

5. Apply a 3 mm (0.125 in) wide bead of Loctite 640 around drive shaft circumference as illustrated.
6. Fit wheel hub to drive shaft and align to axle. The Loctite will smear along the length of the splines as the wheel hub is fitted to the drive shaft.
7. Fit bolts securing wheel hub to axle and tighten to 100 Nm (74 lbf.ft).
8. Fit new drive shaft nut and lightly tighten.
9. Fit rear brake disc. BRAKES, REPAIRS, Brake disc - rear.

tighten drive shaft nut to 490 Nm (360 lbf.ft). Stake drive shaft nut. The drive shaft nut must be tightened before the Loctite has cured.

harness to harness bracket and brake hose.

lbf.ft).