L322 Range Rover Service Procedures
EXTERIOR FITTINGS
76-2-4
REPAIRS
Liner - rear wheel arch - single
$% 76.10.49
Remove
1. Raise rear of vehicle.
WARNING: Do not work on or under a
vehicle supported only by a jack. Always
support the vehicle on safety stands.
2. Remove road wheel.
3. Remove 2 scrivets securing wheel arch liner to
sill and bumper.
4. Remove 3 plastic nuts securing inner wheel
arch liner.
5. Remove 4 hexagonal headed screws securing
wheel arch liner.
6. Release and remove wheel arch liner.
Refit
1. Position wheel arch liner to inner wing.
2. Fit and secure plastic nuts to studs.
3. Fit and tighten screws securing wheel arch liner
to wing and bumper.
4. Fit and secure scrivets.
5. Fit road wheel and tighten nuts to 140 Nm (103
lbf.ft).
6. Remove stands and lower vehicle.
Spoiler - tailgate
$% 76.10.91
Remove
1. Remove upper tailgate finisher.
DOORS, REPAIRS, Trim finisher -
2. Remove 3 bolts securing spoiler to tailgate.
3. Disconnect multiplug from harness.
4. Close upper tailgate.
5. Slide spoiler rearward and release from clips.
Release Central High Mounted Stop Light
(CHMSL) harness from tailgate and remove
spoiler.
NOTE: Do not carry out further dismantling if
component is removed for access only.
6. Remove 4 screws securing CHMSL to spoiler,
release harness from spoiler and remove lamp.
Refit
1. Position CHMSL and harness to spoiler, secure
with screws.
2. Fit and secure spoiler to tailgate, tighten bolts
to 10 Nm (7 lbf.ft).
3. Open upper tailgate.
4. Connect multiplug.
5. Fit upper tailgate finisher.