landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Description & Operation|Page 274 > < Description & Operation
Page 2
background image

 

GENERAL  

NOTE:  

 
The dynamic suspension system is a four corner air suspension system which is fitted to higher specification vehicles in 
place of the conventional damper and coil spring suspension used on non-air suspension models.  
 
The dynamic suspension system is electronically controlled by an air suspension control module which controls the air 
supply unit, reacts to inputs from four height sensors and distributes air around the system via valve blocks.  
 
The main air suspension system components are:  
 

l

Air suspension control module  

l

Air supply unit  

l

Four height sensors  

l

Three valve block assemblies  

l

Reservoir  

l

Air harness  

l

Four suspension air spring damper modules.  

The four corner air suspension system maintains the vehicle height under all operating conditions by controlling the mass 
of air in the air springs. The air suspension control module uses signals from the four height sensors to maintain the 
correct suspension height. This is achieved by operating pneumatic control valves to increase or decrease the mass of air 
in the air spring damper modules.  
 
The air suspension system has three driver selectable, pre-determined ride heights. A driver interface indicates the 
selected ride height and direction of movement. Additional information is also relayed to the driver via the instrument 
cluster message center (where fitted) and by audible warnings also transmitted by the instrument cluster.  
 
Height changes can only be made when the engine is running and the driver's and passenger doors are closed.  
 
Access height can be selected with the engine not running, within 40 seconds of moving the ignition switch to the off 
position provided the driver's door has not been opened in this time.  
 

5

 -

Rear RH height sensor

6

 -

Rear RH air spring damper module

7

 -

Air supply unit silencer

8

 -

Rear LH air spring damper module

9

 -

Air filter

10

 -

Rear valve block

11

 -

Rear LH height sensor

12

 -

Upper acoustic cover

13

 -

Lower acoustic cover

14

 -

Air supply unit

15

 -

Reservoir valve block

16

 -

Air reservoir

17

 -

Front LH height sensor

18

 -

Front LH air spring damper module

19

 -

Front valve block

 

This section covers the air suspension control system. 

 

Front suspension is detailed in a separate section. For additional information, refer to  Front Suspension  (204-01 
Front Suspension,  Description and Operation). 

 

Rear suspension is detailed in a separate section. For additional information, refer to  Rear Suspension  (204-02 
Rear Suspension,  Description and Operation). 

 

Terrain Response™ is detailed in a separate section. For additional information, refer to  Ride and Handling 
Optimization  (204-06 Ride and Handling Optimization,  Diagnosis and Testing). 

Description & Operation|Page 274 > < Description & Operation