Engine front cover installation note
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Mechanical › Engine front cover installation note
EngineEngine front cover installation note · page 1 of 2
Courtesy of MAZDA MOTORS CORP.
- Remove the retaining wire or paper clip from the chain tensioner to apply tension to the timing chain.
ENGINE FRONT COVER INSTALLATION NOTE
NOTE: Install the front oil seal before performing the following procedure.
- Apply silicone sealant to the engine front cover as shown in Fig. 38.
CAUTION: Install the engine front cover within 10 minutes of applying the silicone sealant.
Silicone sealant is not need in area C as indicated below due to an existing.
Thickness
A: 2.0-3.0 mm {0.079-0.118 in}
B: 1.5-2.5 mm {0.059-0.098 in}
Parts & tools for this job For 2006 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 2006 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.