Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Variable valve timing actuator inspection [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Mechanical › Variable valve timing actuator inspection [lf]
EngineVariable valve timing actuator inspection [lf] · page 1 of 2
ENGINE – Mechanical – figure
Fig. 70: Removing/Installing Drive Belt Auto Tensioner [LF] (With Torque Specifications)
Courtesy of MAZDA MOTORS CORP.

VARIABLE VALVE TIMING ACTUATOR INSPECTION [LF]

CAUTION: Variable valve timing actuator can not be disassembled it is a precision unit.

  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [LF] .)
  4. Disconnect the ventilation hose. (See QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [LF] .)
  5. Remove the front suspension tower bar (joint). (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
  6. Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [LF] .)
  7. Disconnect the OCV connector.
  8. Disconnect the P/S pressure switch connector.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.