Idle speed inspection
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Mechanical › Idle speed inspection
See also: live page (the same text is also in the 2008 2.0L manual)
- Verify that the ignition timing (M-MDS: SPARKADV PID) is within the specification using M-MDS or equivalent.
Ignition timing
Approx. BTDC 8°
- Verify that ignition timing advances when the engine speed increases gradually.
- If there is malfunction, refer to "ENGINE SYMPTOM TROUBLESHOOTING [LF] ".
IDLE SPEED INSPECTION
NOTE: Idle speed is not adjustable.
Idle speed verification requires M-MDS or equivalent.
- Verify that the idle speed (M-MDS: RPM PID) is within the specification using M-MDS or equivalent.
- If there is malfunction, refer to "ENGINE SYMPTOM TROUBLESHOOTING [LF] ".
Idle speed
No load: 670-770 rpm (MT), 700-800 rpm (AT)
Electrical loads (38-48 A): 700-800 rpm
Electrical loads (more than 48 A): 800-900 rpm
P/S ON: 700-800 rpm (MT), 750-850 rpm (AT)
A/C ON: 825-925 rpm (MT), 775-875 rpm (AT)
IDLE MIXTURE INSPECTION
- Verify that the idle speed and ignition timing are within the specification. (See IDLE SPEED INSPECTION .) (See IGNITION TIMING INSPECTION .)
- Insert an exhaust gas analyzer to the tailpipe.
- Verify that the CO and HC concentrations are within the regulation.
- If there is malfunction, refer to "ENGINE SYMPTOM TROUBLESHOOTING [LF] ".
Idle mixture
HC concentration: Within the regulation
CO concentration: Within the regulation
Parts & tools for this job For 2006 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 2006 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.