Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Cylinder head gasket replacement [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Mechanical › Cylinder head gasket replacement [lf]
EngineCylinder head gasket replacement [lf] · page 1 of 2
ENGINE – Mechanical – figure
Fig. 46: Cylinder Head Cover Bolt Tightening Sequence
Courtesy of MAZDA MOTORS CORP.

CYLINDER HEAD GASKET REPLACEMENT [LF]

WARNING: Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.

Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Procedure". (See BEFORE SERVICE PRECAUTION [LF] .)

  1. Perform "Fuel Line Safety Procedures". Leave the fuel pump relay removed. (See BEFORE SERVICE PRECAUTION [LF] .)
  2. Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [LF] .)
  4. Remove the front suspension tower bar (joint, right side, left side). (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
  5. Remove the air cleaner. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.