Cylinder head gasket replacement [lf] (page 2 of 2)
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Mechanical
EngineCylinder head gasket replacement [lf] · page 2 of 2
- Remove the dynamic chamber. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
- Remove the ignition coil. (See IGNITION COIL REMOVAL/INSTALLATION [LF] .)
- Remove the drive belt. (See TIMING CHAIN REMOVAL/INSTALLATION [LF] .)
- Remove the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [LF] .)
- Remove the P/S oil pump with the oil hose still connected and position the P/S oil pump so that it is out of the way. (See POWER STEERING OIL PUMP REMOVAL/INSTALLATION .)
- Remove the timing chain. (See TIMING CHAIN REMOVAL/INSTALLATION [LF] .)
- Remove the wiper arm. (See WIPER ARM AND BLADE REMOVAL/INSTALLATION .)
- Remove the cowl grille. (See COWL GRILLE REMOVAL/INSTALLATION .)
- Remove the side cowl grille. (See SIDE COWL GRILLE REMOVAL/INSTALLATION .)
- Remove the service hole cover. (See EGR VALVE REMOVAL/INSTALLATION [LF] .)
- Disconnect the generator, but do not remove it from the vehicle. Fix the generator using a rope to prevent it from falling. (See GENERATOR REMOVAL/INSTALLATION [LF] .)
- Remove the exhaust manifold. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF] .)
- Remove in the order indicated in Fig. 47 .
- Install in the reverse order of removal.
- Inspect the compression. (See COMPRESSION INSPECTION [LF] .)
- Start the engine and:
- Inspect for the engine coolant leakage.
- Verify the ignition timing, idle speed and idle mixture. (See ENGINE TUNE-UP [LF] .)
Parts & tools for this job For 2006 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 2006 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.