Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Camshaft installation note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Mechanical › Camshaft installation note
EngineCamshaft installation note
ENGINE – Mechanical – figure
Fig. 51: Cylinder Head Bolt Tightening Sequence
Courtesy of MAZDA MOTORS CORP.

CAMSHAFT INSTALLATION NOTE

  1. Set the cam position of No.1 cylinder at the top dead center (TDC) and install the camshaft.
  2. Temporarily tighten the camshaft bearing caps evenly in two or three steps.
  3. Tighten the camshaft cap bolts in the order shown in Fig. 52 with the following two steps.
  4. Tighten to 5.0-9.0 N.m {51.0-91.7 kgf.cm, 44.3-79.6 in.lbf}
  5. Tighten to 14.0-17.0 N.m {1.5-1.7 kgf.m, 10.4-12.5 ft.lbf}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.