Engine, transmission, crossmember component removal note
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Mechanical › Engine, transmission, crossmember component removal note
EngineEngine, transmission, crossmember component removal note
- Leakage of engine oil, engine coolant, ATF, MT oil, and fuel
- Ignition timing, idle speed, and idle mixture (CO and HC) (See ENGINE TUNE-UP [LF] .)
- Front wheel alignment (See FRONT WHEEL ALIGNMENT .)
- Engine-driven accessories operation
- Perform the on-road test and verify that there is no vibration or noise.
ENGINE, TRANSMISSION, CROSSMEMBER COMPONENT REMOVAL NOTE
- Secure the engine, transmission, and crossmember component using an engine lifter.
ENGINE DISASSEMBLY/ASSEMBLY [LF]
- Remove the transmission from the engine. (See TRANSMISSION REMOVAL/INSTALLATION [M15M-D] .) (See TRANSMISSION REMOVAL/INSTALLATION [P66M-D] .) (See AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION [SJ6A-EL] .)
- Remove the following parts:
- The clutch unit (MT) (See CLUTCH UNIT REMOVAL/INSTALLATION .)
- The ignition coil (See IGNITION COIL REMOVAL/INSTALLATION [LF] .)
- The CMP sensor (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [LF] .)
- The power steering oil pump (See POWER STEERING OIL PUMP REMOVAL/INSTALLATION .)
- The fuel distributor and fuel injector (See FUEL INJECTOR REMOVAL/INSTALLATION [LF] .)
- The intake-air system (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
- The exhaust system (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF] .)
- The CKP sensor (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [LF] .)
- Remove in the order indicated in Fig. 70 .
- Install in the reverse order of removal.
Parts & tools for this job For 2006 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 2006 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.