Spool valve operation inspection
- Make
- Mazda
- Model
- MX-5 (NC) Factory Workshop Manual
- Year
- 2006–2008
- Section
- Mechanical › Spool valve operation inspection
EngineSpool valve operation inspection
Courtesy of MAZDA MOTORS CORP.
SPOOL VALVE OPERATION INSPECTION
- Remove the battery cover.
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
- Remove the oil control valve.
- Verify that the spool valve in the oil control valve is in the maximum valve timing retard position as indicated in Fig. 76 .
- If not as specified, replace the oil control valve. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION [LF] .)
Courtesy of MAZDA MOTORS CORP.
- Verify that the battery is fully charged.
- If not as specified, recharge the battery. (See BATTERY INSPECTION [LF] .)
- Apply battery positive voltage between the oil control valve terminals and verify that the spool valve operates and moves to the maximum valve timing advance position.
- If not as specified, replace the oil control valve.
Parts & tools for this job For 2006 Mazda MX-5
- PARTEngine gasket setSearch: Mazda MX-5 2006 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.