Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Valve clearance adjustment [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Mechanical › Valve clearance adjustment [lf]
EngineValve clearance adjustment [lf] · page 1 of 17

NOTE: Make sure to note down the measured values for choosing the suitable replacement tappets.

Valve clearance [Engine cold]

IN: 0.22-0.28 mm {0.0087-0.0110 in}

EX: 0.27-0.33 mm {0.0107-0.0129 in}

  1. Install the cylinder head cover. (See CYLINDER HEAD COVER INSTALLATION NOTE .)
  2. Install the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION [LF] .)
  3. Connect the P/S pressure switch connector.
  4. Connect the OCV connector.
  5. Install the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [LF] .)
  6. Install the front suspension tower bar (joint). (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
  7. Connect the ventilation hose. (See QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [LF] .)
  8. Install the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [LF] .)
  9. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  10. Install the battery cover.

VALVE CLEARANCE ADJUSTMENT [LF]

  1. Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION [LF] .)
  3. Remove the air cleaner. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF] .)
  4. Disconnect the ventilation hose. (See QUICK RELEASE CONNECTOR (EMISSION SYSTEM) REMOVAL/INSTALLATION [LF] .)
  5. Remove the front suspension tower bar (joint). (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
  6. Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [LF] .)
  7. Disconnect the OCV connector.
  8. Disconnect the P/S pressure switch connector.
  9. Remove the ignition coils. (See IGNITION COIL REMOVAL/INSTALLATION [LF] .)
  10. Remove the cylinder head cover. (See TIMING CHAIN REMOVAL/INSTALLATION [LF] .)
  11. Remove the drive belt. (See DRIVE BELT REPLACEMENT [LF] .)
  12. Remove the engine front cover lower blind plug.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.