Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Valve clearance adjustment [lf] (page 13 of 17)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Mechanical
EngineValve clearance adjustment [lf] · page 13 of 17
ENGINE – Mechanical – figure
Fig. 24: Holding Exhaust Camshaft Using Wrench On Case Hexagon
Courtesy of MAZDA MOTORS CORP.
  1. Tighten the exhaust camshaft sprocket lock bolt.

Tightening torque

69-75 N.m {7.1-7.6 kgf.m, 50.9-55.3 ft.lbf}

  1. Remove the SST from the camshaft.
  2. Remove the SST from the block lower blind plug.
  3. Rotate the crankshaft clockwise two turns until the TDC position.
    • If not aligned, loosen the crankshaft pulley lock bolt and repeat from Step 16.
  4. Apply silicone sealant to the engine front cover upper blind plug.
  5. Install the engine front cover upper blind plug.

Tightening torque

8.0-11.5 N.m {82-117 kgf.cm, 71-101 ft.lbf}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.