Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Valve clearance adjustment [lf] (page 8 of 17)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Mechanical
EngineValve clearance adjustment [lf] · page 8 of 17

See also: live page (the same text is also in the 2008 2.0L manual)

ENGINE – Mechanical – figure
Fig. 19: Identifying Camshaft Cap Bolts Loosening Sequence
Courtesy of MAZDA MOTORS CORP.
  1. Remove the camshafts.
  2. Remove the tappet.
  3. Select proper adjustment tappet.

New adjustment tappet

= Removed tappet thickness + Measured valve clearance - Standard valve clearance (IN: 0.25 mm {0.0098 in}, EX: 0.30 mm {0.0118 in})

Valve clearance [Engine cold]

IN: 0.22-0.28 mm {0.0087-0.0110 in}

EX: 0.27-0.33 mm {0.0107-0.0129 in}

  1. Install the camshaft with No.1 cylinder camshaft lobes aligned with the TDC position.
  2. Tighten the camshaft cap bolt with the following two steps.
  3. Tighten to 5.0-9.0 N.m {51.0-91.7 kgf.cm, 44.3-79.6 in.lbf}.
  4. Tighten to 14.0-17.0 N.m {1.5-1.7 kgf.m, 10.4-12.5 ft.lbf}.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.