ENGINE COOLANT TEMPERATURE SENSOR - R.R.

Operation 1060G14 · DIESEL INJECTION PRESSURE PUMP ELECTRONIC CONTROL

1.9 Multijet

Removing

Op. 5530B10 BATTERY - R+R

1. Disconnect the electrical connection from the engine coolant temperature sensor.

2. Undo the engine coolant temperature sensor and remove it.

Refitting

1. Place the engine coolant temperature sensor in its housing and tighten it to the recommended torque.

2. Connect the electrical connection to the engine coolant temperature sensor.

Op. 5530B10 BATTERY - R+R

1.3 Multijet

Removing

- Position the vehicle on a lift.

Op. 0010T20 ENGINE COOLANT - CHANGE

Op. 5530B10 BATTERY - R+R

Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R

1. Undo the bolts fixing the rigid engine oil vapour recovery pipe.

2. Loosen the band and disconnect the flexible engine oil vapour recircuation pipe from the rigid pipe.

1. Disconnect the electrical connection for the engine coolant temperature sensor.

2. Undo the engine coolant temperature sensor and remove it.

Refitting

- Place the engine coolant temperature sensor in its housing and tighten it to the recommended torque.

Renew the sealant on the sensor thread.

- Connect the electrical connection to the engine coolant temperature sensor.

- Connect the engine oil vapour recirculation hose to the rigid pipe and tighten the band.

- Tighten the bolts fixing the rigid engine oil vapour recovery pipe.

Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R

Op. 5530B10 BATTERY - R+R

- Connect the radiator lower coolant outlet hose, radiator side, and tighten the band.

Op. 0010T20 ENGINE COOLANT - CHANGE

- Remove the vehicle from the lift.