Workshop Manuals Factory service & repair

Fiat Grande Punto Factory Service Manual (2005-2012)08 · Engine

08 · Engine

Rpm sensor efficiency check

Make: Fiat
Model: Grande Punto Factory Service Manual
Year: 2005–2012
Section: Diesel injection system › Rpm sensor efficiency check

‹ Prev Debimeter operation check Next › Check timing sensor operation

EngineRpm sensor efficiency check

RPM SENSOR EFFICIENCY CHECK

Check 1060GA

1.3 Multijet

STEP	CHECK TO BE PERFORMED	RESOLUTION IF THE CHECK IS NOT OK
1	Turn the ignition key ON. The revolutions must be higher than 60 rpm.	Move on to Step 4
2	With the engine idling and warm, with all users off and the accelerator pedal not operated, the engine rpm must be in a range between 780 and 1,100 rpm.	Move on to Step 4
3	Operate the accelerator pedal at maximum for a short time. The engine rpm must roughly coincide with the reading visible on the instrument panel. The test can be considered over	Move on to Step 4
4	Turn the ignition key OFF. Disconnect the cable loom connector from the engine management control unit connector A. Turn the ignition key ON. Measure the voltage between control unit Pins 43 and 59 See M010 ENGINE MANAGEMENT ECU and Earth, checking it is less than 0.3 V ]	Repair or if necessary replace the electrical wiring between the rpm sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
5	Turn the ignition key OFF. Measure the resistance between control unit Pins 43 and 59 See M010 ENGINE MANAGEMENT ECU and Earth, checking it is greater than 500 kOhms Move on to Step 7	Move on to Step 6
6	If faults are present, repair or if necessary replace the electrical wiring between the rpm sensor and the engine control unit. See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT The test can be considered over	Change the rpm sensor Op. 1060G20 ENGINE RPM SENSOR - R.R.
7	Disconnect the wiring harness connector from the rpm sensor. Measure the resistance across control unit sensor Pin 43 (wiring side) See M010 ENGINE MANAGEMENT ECU and sensor Pin 1 (wiring side) See K046 RPM SENSOR checking that it is less than 5 Ohm.	Repair or if necessary replace the electrical wiring between the rpm sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
8	Measure the resistance across control unit sensor Pin 59 (wiring side) See M010 ENGINE MANAGEMENT ECU and sensor Pin 2 (wiring side) See K046 RPM SENSOR checking that it is less than 5 Ohm.	Repair or if necessary replace the electrical wiring between the rpm sensor and the engine control unit See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
9	Check that the rpm sensos is not affected by faults such as intermittent contacts, missing teeth, incorrect reference point, incorrect gap positino (this should be between 0.5 and 1.5 mm)	Restore the correct positioning or replace the rpm sensor if necessary Op. 1060G20 ENGINE RPM SENSOR - R.R.
10	Change the rpm sensor Op. 1060G20 ENGINE RPM SENSOR - R.R.

‹ Prev Debimeter operation check Next › Check timing sensor operation

Parts & tools for this job For 2005 Fiat Grande Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.