Gasket - intermediate plate (page 2 of 3)

11. Mount DTI gauge and position gauge probe onto LRT-44-003/1 and zero gauge. Intermediate plate
12. Check that the axial end-float is between 0.2 to 0.4 mm (0.008 to 0.016 in). If end-float in not

$% 44.17.20 within limits, replace existing thrust washer, positioned at rear of intermediate plate, with a

Remove

suitable thickness thrust washer to give the required end-float.

13. Remove DTI gauge and base plate.
14. Fit torque converter oil seal. AUTOMATIC GEARBOX - ZF4HP22 - 24, REPAIRS, Torque converter and oil seal.
1. Remove intermediate plate gasket. AUTOMATIC GEARBOX - ZF4HP22 - 24, REPAIRS, Gasket - intermediate plate.

2. Remove selective thrust washer from intermediate plate.

2 4 3

4

3

3. Remove 2 M14 Allen plugs from intermediate plate, remove and discard sealing washers.
4. Remove 2 M20 plugs from intermediate plate, remove and discard sealing washers.
5. Remove 2 oil cooler pipe adaptors from intermediate plate.

6. Remove 8 bolts securing fluid pump to intermediate plate and carefully remove pump from intermediate plate.