L322 Range Rover Service Procedures
RESTRAINT SYSTEMS
REPAIRS
75-9
4. Remove 4 Torx screws securing airbag module
and remove airbag.
WARNING: Store the airbag module with the
deployment side uppermost. If it is stored
deployment side down, accidental
deployment will propel the airbag module
with enough force to cause serious injury.
WARNING: Store the airbag module or seat
pre-tensioner in a designated storage area.
If there is no designated storage area
available, store in the locked luggage
compartment/loadspace area of the vehicle,
and inform the workshop supervisor.
Refit
NOTE: If the SRS component is to be replaced,
the bar code of the new unit must be recorded.
1. Carefully fit airbag module and tighten screws
evenly to 10 Nm (7 lbf.ft).
2. Connect airbag multiplug.
3. Fit headlining.
4. Connect battery leads, earth lead last.
Crash sensor - side
$% 76.74.11
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
WARNING: It is imperative that before any work
is undertaken on the SRS system, the
appropriate information is read thoroughly.
WARNING: Always disconnect both battery leads
before beginning work on the SRS system.
Disconnect the negative lead first. Never reverse
connect the battery.
Remove
1. Make the SRS system safe.
Supplementary Restraint System (SRS)
Precautions.
2. Remove 'B' post finisher.
Trim finisher - 'B' post - upper.
3. Remove front and rear carpet retainer.
4. Remove Torx bolt securing seat belt reel to 'B'
post and position the seat belt reel aside.
5. Remove 2 scrivets securing centre carpet
retainer to 'B' post and remove the carpet
retainer.