L322 Range Rover Service Procedures
RESTRAINT SYSTEMS
REPAIRS
75-15
4. Fit rear console.
5. Fit 'B' post upper finisher.
Trim finisher - 'B' post - upper.
6. Fit 'D' post upper finisher.
Trim finisher - 'D' post - upper.
7. Fit 'E' post finisher.
8. Fit grab handles.
9. Fit sun visor.
INTERIOR FITTINGS, REPAIRS, Sun
10. Fit fascia carrier.
11. Fit door aperture seals.
12. Connect battery leads, earth lead last.
Diagnostic control unit (DCU)
$% 76.74.68
If the ECU is to be replaced then Testbook/T4 must
be connected and correct procedures adhered to,
prior to battery disconnection.
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
WARNING: It is imperative that before any work
is undertaken on the SRS system, the
appropriate information is read thoroughly.
WARNING: Always disconnect both battery leads
before beginning work on the SRS system.
Disconnect the negative lead first. Never reverse
connect the battery.
CAUTION: The SRS DCU must be replaced after
every deployment has occurred.
Remove
1. Make the SRS system safe.
Supplementary Restraint System (SRS)
Precautions.
2. Remove centre console.
3. Remove air suspension switch panel.
Switch panel - air suspension.
4. Disconnect multiplug from heater motor.
5. Remove 2 screws securing heater motor to
mounting bracket.
6. Release and remove heater motor.