L322 Range Rover Service Procedures
RESTRAINT SYSTEMS
75-14
REPAIRS
10. Remove 2 screws securing headlining.
11. Carefully lower edge of headlining for access to
airbag fixings.
12. Remove 2 Torx screws securing airbag to 'A'
post.
13. Remove Torx screw securing airbag webbing
to 'A' post.
14. Remove Torx screw securing airbag webbing
to cantrail.
15. Release 4 clips securing airbag module.
16. Remove airbag module.
WARNING: Store the airbag module with the
deployment side uppermost. If it is stored
deployment side down, accidental
deployment will propel the airbag module
with enough force to cause serious injury.
WARNING: Store the airbag module or seat
pre-tensioner in a designated storage area.
If there is no designated storage area
available, store in the locked luggage
compartment/loadspace area of the vehicle,
and inform the workshop supervisor.
Refit
NOTE: If the SRS component is to be replaced,
the bar code of the new unit must be recorded.
1. Carefully fit airbag and secure clips.
2. Fit airbag module to cantrail and 'A' post and
tighten Torx screws to 10 Nm (7 lbf.ft).
3. Fit and tighten screws securing headlining.
M76 4462