L322 Range Rover Service Procedures
RESTRAINT SYSTEMS
REPAIRS
75-13
5. Remove airbag module.
WARNING: Store the airbag module with the
deployment side uppermost. If it is stored
deployment side down, accidental
deployment will propel the airbag module
with enough force to cause serious injury.
WARNING: Store the airbag module or seat
pre-tensioner in a designated storage area.
If there is no designated storage area
available, store in the locked luggage
compartment/loadspace area of the vehicle,
and inform the workshop supervisor.
Refit
NOTE: If the SRS component is to be replaced,
the bar code of the new unit must be recorded.
1. Position airbag module to door, fit new bolts
and tighten to 9 Nm (7 lbf.ft).
2. Connect multiplug to airbag module.
3. Fit door trim casing.
4. Connect battery leads, earth lead last.
Airbag module - head - front
$% 76.74.40
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
WARNING: It is imperative that before any work
is undertaken on the SRS system, the
appropriate information is read thoroughly.
WARNING: Always disconnect both battery leads
before beginning work on the SRS system.
Disconnect the negative lead first. Never reverse
connect the battery.
Remove
1. Make the SRS system safe.
Supplementary Restraint System (SRS)
Precautions.
2. Remove fascia carrier.
3. Remove sun visor.
INTERIOR FITTINGS, REPAIRS, Sun
4. Remove grab handles.
5. Release door aperture seals to release
headlining.
6. Remove 'B' post upper finisher.
Trim finisher - 'B' post - upper.
7. Release 'D' post upper finisher.
Trim finisher - 'D' post - upper.
8. Remove 'E' post finisher.
9. Remove rear console from headlining.