Glow plugs (page 2 of 2)

Refit

1. Thoroughly clean glow plugs and glow plug seating area in cylinder head.
2. Apply a suitable anti-seize compound to threads of glow plugs.
3. Fit glow plugs and tighten to 20 Nm.
4. Fit terminal and feed leads to glow plugs.

NOTE: Harness feed lead must be connected to glow plug No. 2.

5. Tighten terminal nuts to 2.5 Nm.
6. Engines with 4 glow plugs: Fit fuel injection pump. See this section.
7. Clean mating faces of coolant outlet elbow and cylinder head.
8. Fit new seal to coolant outlet elbow.
9. Position coolant outlet elbow to cylinder head, fit bolts and tighten to 25 Nm.
10. Connect radiator top hose to coolant outlet elbow and tighten clip.
11. Align dipstick tube bracket to coolant outlet elbow and secure with bolt.
12. Connect temperature gauge sensor Lucar.
13. Connect multiplug to ECT sensor.
14. Air conditioning model: Refit alternator. See ELECTRICAL, Repairs. Intercooler model: Refit plenum chamber. See this section.
15. Fit engine acoustic panel. See BODY, Exterior fittings.
16. Refill cooling system. See COOLING SYSTEM - ’L’ SERIES, Repairs.
17. Connect battery earth lead.