Brake Disc, Precision Turning (Brakes)

Make

Vauxhall

Model

Corsa C

Section

Repair Instructions › Brake Disc, Precision Turning

BrakesBrake Disc, Precision Turning

Brake Disc, Precision Turning   Remove 1.   Remove corresponding wheels •   Mark position in relation to centre of wheel Warning:   Do not use brake discs which cannot be re-machined within the nominal values. 2.   Check surface condition of brake disc •   Measure brake disc thickness with MKM-230-A permissible minimum thickness of brake discs after precision turning: Front brake disc – solid Z 10 XE, Z 12 XE   9.0 mm Front brake disc – ventilated Z 10 XE, Z 12 XE C   18.0 mm Front brake disc – ventilated Z 14 XE, Y 17 DT, Y 17 DTL, Z 18 XE   22.0 mm Rear brake disc Z 18 XE   9.0 mm Note:   Once these dimensions have been attained, new brake linings may only be installed on one further occasion. Thereafter, the brake discs must be replaced. Important:   Read manufacturer's instructions before machining! 3.   Precision turn the corresponding brake discs Note:   Machine the brake discs on the right side first. The brake disc machining unit is applied to the left side turned through 180°, the settings for the right side can be transferred. Machine the rear brake discs on the left side first. On the right side, the brake disc machining unit is applied turned through 180°, the settings for the left side can be transferred. •   Remove corresponding retaining frame for brake calliper or   Install 4.   Install corresponding retaining frame or 5.   Attach corresponding wheels 110 Nm

08 Brakes