Propeller shaft - front.

Refit 20. Position high/low ratio selector cable and

1. Fit new input shaft oil seal. TRANSFER BOX - LT230SE, 21. Clean handbrake and mating face. REPAIRS, Oil seal - input shaft. 22. Position handbrake back plate and tighten
2. Clean transfer box to gearbox mating faces.
3. Raise transfer box on jack and align to guide 23. Clean handbrake drum. studs LRT-41-009. 24. Fit handbrake drum and tighten retaining
4. Clean transfer box to gearbox bolt threads.
5. Apply Loctite 290 to bolt and stud threads. 25. Fit front propeller shaft.
6. Fit and lightly tighten 2 bolts and nut securing transfer box to gearbox. If new stud is to be fitted, apply Loctite 290 to stud threads and 26. Fit rear propeller shaft. tighten to 45 Nm (33 lbf.ft).
7. Remove guide studs, fit and lightly tighten remaining 3 bolts. 27. Clean exhaust silencer and mating face.
8. Tighten bolts and nut by diagonal selection to 28. Position silencer, fit new gasket , connect 45 Nm (33 lbf.ft).
9. Position gearbox RH mounting and tighten bolts to 85 Nm (63 lbf.ft). 29. Refill transfer box with oil.
10. Tighten gearbox RH mounting nut to 48 Nm (35 lbf.ft).
11. Remove 4 bolts securing support plate to 30. Fit front exhaust pipe. gearbox jack.
12. Remove 4 bolts securing support plate LRT-99- 010 to transfer box and remove plate.
13. Clean bottom plate bolt threads.
14. Apply Loctite 290 to threads of 4 bottom plate bolts.
15. Fit 4 bolts securing bottom plate to transfer box and tighten to 25 Nm (18 lbf.ft).
16. Position breather pipe and secure to bulkhead clip.
17. Connect multiplug to reverse light switch.

18. If fitted - Connect Lucars to differential lock switch.

19. Fit multiplug and cable tie to transfer gearbox bracket.

secure with clevis pin.

bolts to 75 Nm (55 lbf.ft).

screw.

PROPELLER SHAFTS, REPAIRS,

Propeller shaft - front.

PROPELLER SHAFTS, REPAIRS,

Propeller shaft - rear.

mounting rubbers and tighten nuts to 40 Nm (30 lbf.ft).

MAINTENANCE, PROCEDURES, Transfer box.

MANIFOLDS AND EXHAUST SYSTEMS - Td5, REPAIRS, Pipe - front.