Fixing Body Side Panel - Sill Section of L322 Range Rover
PANEL REPAIRS
-34
REPAIRS
Body side panel - sill section
In this procedure the sill section of the body side
panel is changed.
Remove
1. Disconnect battery earth lead.
2. Disconnect alternator.
3. Remove rear road wheel.
4. Remove front and rear doors.
5. Remove SRS side crash sensor.
6. Remove front seat belt.
7. Remove front and rear door tread plates.
8. Remove front and rear door aperture seals.
9. Remove sill finisher.
Extension - spoiler - front bumper.
10. Remove front seat.
11. Remove rear seat cushion.
12. Release carpet from door apertures and
position aside.
13. RH side: Remove air reservoir.
FRONT SUSPENSION, REPAIRS, Air
14. Remove exhaust assembly.
- Td6, REPAIR, Exhaust system and
mountings.
15. Remove fuel tank shield.
16. Release wiring harnesses from sill area and
position aside.
Repair
1. Remove existing panel(s), prepare panel joint
faces and install new panel(s) in accordance
with Panel Replacement Procedure. Punch or
drill holes in new panel for plug welding as
shown.
Refit
1. Secure harness to sill.
2. Position carpet to inner sill.
3. Fit fuel tank shield.
4. Fit exhaust assembly.
- Td6, REPAIR, Exhaust system and
mountings.
5. RH side: Fit air reservoir.
FRONT SUSPENSION, REPAIRS, Air
6. Fit front seat.
7. Fit rear seat cushion.
8. Fit front and rear door aperture seals.
9. Fit front and rear door tread plates.
10. Fit sill finisher.
Extension - spoiler - front bumper.
11. Fit front seat belt.