Range Rover P38 - Automatic Gearbox Repair - Selector Shaft Seal Replacement (Page 787)
44
AUTOMATIC GEARBOX
NEW RANGE ROVER
8
REPAIR
15. Remove 4 bolts from each propeller shaft flange.
16. Release propeller shafts and tie aside.
17. Lower gearbox for access.
18. Remove split pin securing gear selector cable
trunnion to gear selector lever and release
trunnion.
19. Remove 2 bolts securing gear selector cable
abutment bracket and harness support bracket
to gearbox.
20. Position selector cable and bracket aside.
21. Lower gearbox support to gain access to
selector shaft.
22. Remove valve block.
See this section.
23. Disconnect harness from gear selector switch
multiplug and release multiplug from bracket.
24. Remove nut securing selector shaft lever and
release lever from shaft.
25. Remove bolt and nut securing gear selector
switch to gearbox and remove switch.
26. Drift out and discard selector quadrant roll pin.
Remove selector shaft.
27. Remove selector quadrant and connecting rod.
28. Remove oil seal taking care not to damage seal
housing.