Workshop Manuals Factory service & repair Rover
Rover 400 Workshop Manual (1995-2000)16 · Manifold & exhaust systems
16 · Engine

Tail pipe - ’t’ series

Make
Rover
Model
400 Workshop Manual
Year
1995–2000
Section
Repairs › Tail pipe - ’t’ series
Manifold & exhaust systemsTail pipe - ’t’ series

TAIL PIPE - ’T’ SERIES

Service repair no - 30.10.22

Remove

  1. Raise vehicle on 4 post ramp.
Tail pipe - ’t’ series – Raise vehicle on 4 post ramp.
  1. Remove 2 nuts securing intermediate pipe to tail pipe.
Tail pipe - ’t’ series – Remove 2 nuts securing intermediate pipe to tail pipe.
  1. Release 3 rubber mountings from tail pipe.
  2. Remove tail pipe.
  3. Remove and discard gasket.

Refit

  1. Clean intermediate pipe and tail pipe mating faces.
  2. Fit NEW gasket to intermediate pipe flange studs.
  3. Fit tail pipe and connect rubber mountings.
  4. Fit nuts to flange and tighten to 45 Nm.
  5. Lower vehicle.

Parts & tools for this job For 1995 Rover 400

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.